Page 1 of 1

help with ATA IRQ's

Posted: Wed Jun 22, 2005 11:16 am
by Anthony
I have been coding on my ata driver for my kernel. and no matter what i do, i can't seem to get either IRQ 14 or 15 to fire.

from my understanding, the nIEN bit needs to be 0 to enable the interrupt. and i know i have properly setup the PIC, and unmasked IRQ14/15.

any help on this would be greatly appreciated.

Re:help with ATA IRQ's

Posted: Thu Jun 23, 2005 2:20 am
by Pype.Clicker
can you get any other of IRQ8..IRQ13 to fire ? if you can't, that probably means you haven't enabled IRQ2 on the master PIC (this is required so that any of the slave IRQs can be delivered)

(hm. surprisingly enough, i see no track of "iEN" in my ATA code ...)