I have been coding on my ata driver for my kernel. and no matter what i do, i can't seem to get either IRQ 14 or 15 to fire.
from my understanding, the nIEN bit needs to be 0 to enable the interrupt. and i know i have properly setup the PIC, and unmasked IRQ14/15.
any help on this would be greatly appreciated.
help with ATA IRQ's
- Pype.Clicker
- Member

- Posts: 5964
- Joined: Wed Oct 18, 2006 2:31 am
- Location: In a galaxy, far, far away
- Contact:
Re:help with ATA IRQ's
can you get any other of IRQ8..IRQ13 to fire ? if you can't, that probably means you haven't enabled IRQ2 on the master PIC (this is required so that any of the slave IRQs can be delivered)
(hm. surprisingly enough, i see no track of "iEN" in my ATA code ...)
(hm. surprisingly enough, i see no track of "iEN" in my ATA code ...)