Hello,
Whenever I use partcopy to write the second stage to it using
partcopy psych2.bin 0 200 -f0 1, it gives me the error message:
"Failed to write destination at offset 1"
Putting the boot sector in works fine using:
partcopy psych.bin 0 200 -f0
Am I writing it wrong if I want the second stage to start at offset 0x1000 on the next sector?
My friend Nelson has it working fine using that way, btw...
partcopy and its problem with me! >:(
-
Warrior
Re:partcopy and its problem with me! >:(
Assuming you padded the second stage to 512 bytes that should work fine.
-
vile
Re:partcopy and its problem with me! >:(
I did, and it didn't work. Also, you told me to not pad it... still didn't work.
-
Warrior
Re:partcopy and its problem with me! >:(
...assuming you would know to put a different length..
-
vile
Re:partcopy and its problem with me! >:(
I have put in the correct lengths, too... it still doesn't work. I have no idea why it's giving me that message no matter what offset I put in
. Can somebody help? I really need to get my second stage put on the disk so I can actually make some progress. Thanks.
Re:partcopy and its problem with me! >:(
So it whould be: partcopy filnamne 0 200 -f0 200, if you want to write a second sector right after the bootsector..PARTCOPY source source_offset length destination {destination_offset}
Only destination_offset is optional. The other parameters are always
required. The offsets and length are always in HEX.
