OSDev.org

Posted: **Mon Oct 27, 2008 1:41 am**

I have two network card:

Vendor id=1106
Device id=3106(rev 86)
Name= D-link DFE530TX, Rev-C1
Linux uses via-rhine III to drive it.

AND

Vendor id=11ab
Device id=4320(rev 13)
Name= Marvell
Linux uses skge to drive it.

I am trying to make a bootable floppy by grub to use netboot and get the kernel from the network. I debugged the Grub code , it stops waiting for an ARP reply forever! Ethernet adapter has not been initialized correctly and the PCI location and function number reported by the grub is wrong!!

Does anyone know of any open source project to derive etherboot/netboot drivers out of linux kernel net drivers?

my email is:
[email protected]

Thank you to read my message.

Posted: **Mon Oct 27, 2008 7:50 am**

logicman112 wrote:my email is:
[email protected]

Yahoo must have a really good spam filter...

JAL

Posted: **Mon Oct 27, 2008 8:12 pm**

I guess some one didn't create a driver for your network card. Or their is something that is grub that does not pick up that hardware. I am not sure. It could be anything otherwise i'll be here all day listing everything. lol

Posted: **Mon Oct 27, 2008 11:41 pm**

I hope you compiled GRUB to support both the cards - if so it may be the problem. Just compile with --enable-via-rhine and disable/unplug the Marvel card.
Did you try --enable-pci-direct?

Sam

OSDev.org

network card is not supported by Grub 0.97

network card is not supported by Grub 0.97

Re: network card is not supported by Grub 0.97

Re: network card is not supported by Grub 0.97

Re: network card is not supported by Grub 0.97