Question about which tools to use, bugs, the best way to implement a function, etc should go here. Don't forget to see if your question is answered in the wiki first! When in doubt post here.
I am trying to write my own OS, and have so far completed a boot-loader, kernel with screen output, interrupt handling, malloc() and stuff like that. Now the problem is, I want to design my own file system. The design part is not the problem, but I can't seem to find any information regarding how to do Disk I/O under protected mode. From reading source code, I can see that it will likely entail a lot of "in" and "out" assembler calls. If anybody can help me out with a code snippet that explains this, or a good tutorial on the subject, I would be most appreciative.
So far, I have managed to figure out most of the commands that need to be passed to the FDC, but the read command is giving me problems. I need to know what normal values are for "bytes per sector", "GAP3 length" and "last track in sector". Also, I would love to know where the data I have read is going to be stored in memory... Is there a way this has to be set up, or will it also be available on the FDC Interface port?
PS: Error I am getting from the FDC is "Command started but terminated abnormally"... Any ideas ?
Hmmm... I'm sorry to say, it didn't. Those were pretty much the values I was using, but it still comes up with the same error. According to the Status registers returned when I do a read command, it fails to find a valid data address mark. Now I am not quite sure what that is and how you put it on a disk, but my disks seems to be missing it. The disk I am trying to read from is a DOS formatted disk with 100K of data on. This is really frustrating the hell out of me. Has anybody on these forums ever written a working FDC driver?
You will need to set up some DMS routines to transfer the data from the floppy drive to your system memory so you can use it. Other then that its pretty straight forward you spin up the floppy disk you seek your track and read the sectors you need. If you need an example of this you can snatch the fdc drivers from the ubixos source.
?